Cartridge heater control
Posted: Wed Nov 03, 2021 8:18 am
Hi guys, newbie to this forum and looking for some advice.
I have a small hot foil press which requires a new controller, it's 240v heating a 400w cartridge heater via a type k thermocouple.
I hate throwing anything away so want to reuse and recycle where I can. The foil press is used for hot foil embossing of one off leather items. The controller I want to use is as per the image attached, iam unsure what the component shown on point's 1, 3 & 4 is dose the fact that the component is shown within the ring of contacts mean it's built in to the controller? Any assistance would be greatly appreciated
Thanks
Richard @ Brockbags_uniquebags (instagram)
I have a small hot foil press which requires a new controller, it's 240v heating a 400w cartridge heater via a type k thermocouple.
I hate throwing anything away so want to reuse and recycle where I can. The foil press is used for hot foil embossing of one off leather items. The controller I want to use is as per the image attached, iam unsure what the component shown on point's 1, 3 & 4 is dose the fact that the component is shown within the ring of contacts mean it's built in to the controller? Any assistance would be greatly appreciated
Thanks
Richard @ Brockbags_uniquebags (instagram)