I have three or possibly five relays each activated by a push button switch. I can arrange for a set of contacts on each relay to feed current to the coil when the push button contacts releases and cuts of the current from the source via the push button switch. I wish to arrange that when any other button is activated the energised relay will be disconnected prior to the newly selected circuit being energised. Can anyone suggest a way that this could be achieved.
Regards All,
Wychwar
- Home
- Calculators
- Index
- Resistance:
- Resistor colour code calculator
- LED series resistor calculator
- Series / parallel resistor calculator
- Capacitance:
- Capacitance unit converter
- Charge / Energy calculator
- Capacitor code calculator
- Series / parallel capacitor calculator
- Inductance:
- Convert colour code to inductance
- Convert inductance to colour code
- Other:
- Ohm Law calculator
- Potential Divider calculator
- Wheatstone Bridge calculator
- Power (wattage) calculator
- Reactance calculator
- Downloads
- Technical Data
- Pin-outs
- Beginners Guide
- Forum
- Links
- FAQ
- Contact
Electronics 2000 Forum
Topic: Relay Control
Disclaimer: No warranty, express nor implied, is given regarding the accuracy of information given
on this forum. No responsibility can be accepted for any inaccuracy of information given here. Views expressed are
not necessarily those of Electronics 2000. If in any doubt seek professional advice.
1 post
| Page 1 of 1
Relay Control
by WYCHWAR » Tue Jun 16, 2009 7:33 pm
- WYCHWAR
- Posts: 3
- Joined: Thu Jan 22, 2009 1:12 pm
1 post
| Page 1 of 1