Electronics 2000

Electronics 2000 Forum

Topic: Help needed please

Disclaimer: No warranty, express nor implied, is given regarding the accuracy of information given on this forum. No responsibility can be accepted for any inaccuracy of information given here. Views expressed are not necessarily those of Electronics 2000. If in any doubt seek professional advice.

Need help with a project? Trying to find a component? Post any general technical questions here.

Help needed please

Postby Bigal999 » Thu Aug 09, 2012 6:31 am

Hi I am hoping someone can help me please.
I am a 58 year old from the north east who has had mental health problems ( conic depression). For the past 3 years but am starting to get better I was an electrician since I left school. But I need to get back into a good place. I have just been offered a place on an HND electronics course and have been offered a job on completion.
Because of my condition I am doing the course by distance learning and that is the problem the course provides components etc but not test equipment.
I have multi meters and a couple of power supply's but I am looking to buy an oscilloscope and a signal generator. One of the tutors said try eBay but a lot of the stuff on there they say turns on but not tested.
So if any one can help me please contact me I don't have a lot of cash but enough I hope
The stuff has to be suitable for digital and analog circuits , logic gates and microprocessors
If any of you are into photography I have around 40 books mainly of different old photographers work and the history of photography .
I also have a Shimano 16meter beast master pole with lots of accessories that has been hardly used if you are into fishing.
Thank you for reading this
Al
Bigal999
 
Posts: 2
Joined: Thu Aug 09, 2012 6:29 am

Re: Help needed please

Postby Biffo » Wed Aug 15, 2012 8:11 am

If you looking for second hand (ie.cheaper) tested, test equipment

then Stewart of Reading has been going for years and has a good reputation

http://www.stewart-of-reading.co.uk/
Biffo
 
Posts: 61
Joined: Sun Mar 09, 2008 3:24 pm

Re: Help needed please

Postby Bigal999 » Wed Aug 15, 2012 12:41 pm

Thank you just looked at there website and prices look good
Bigal999
 
Posts: 2
Joined: Thu Aug 09, 2012 6:29 am

Re: Help needed please

Postby Biffo » Wed Aug 15, 2012 9:41 pm

Oh thanks for the reply that is nice and much appreciated.

A lot of people on the board have given up helping people here simply because when they do, the questioner never bothers to get back with any thanks,feedback or whatever.

Peak Instruments do some very nice component value reader/testers for around the 50-100 pound mark.

good luck with your new career
Biffo
 
Posts: 61
Joined: Sun Mar 09, 2008 3:24 pm


Return to Electronics 2000 General Discussion

cron